Arkansas Hunting banner
1 - 15 of 15 Posts

·
Registered
Joined
·
1,600 Posts
Discussion Starter · #1 ·
What is the best way to keep a stainless steel rifle barrel clean? I have looked at several rifles with these barrels, but just do not know how to take care of them. Any information would be appreciated.
Sportsmanetc.
 

·
Registered
Joined
·
1,600 Posts
Discussion Starter · #8 ·
Thanks guys. I was looking at a K10/22 with a 22 inch barrel in stainless. However, there was this Marlin .22 magnum for sale beside it. :censored: Now I have to make a decision!
Sportsmanetc
 

·
Registered
Joined
·
3,356 Posts
The only thing I worry about on the bore snakes is the wire brush. Doesn't too much scrubbing with one of those were down the groove edges?
You'd have to pull a bronze brush through the barrel a LOT of times before any damage could be seen.
Aluminum cleaning rods will deposit aluminum in your barrel, and if they are dirty, the embedded grit will scratch the bore.
 
1 - 15 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top